Thank You Gift Card Holder

I hope you enjoyed the Blog Hop on Sunday!  Hawaii Ink sure does have a lot of talent!

Here is a little more information on the project I created for the blog hop.

Thank You Gift Card 1Here is how the gift card holder started out before making it extra awesome.  I used Coastal Cabana cardstock and cut it out to be 9-1/4″ by 5-1/4″.  Then, with the cardstock running in landscape orientation, I scored at the 1-1/2″ and 6″ marks.  Turning the cardstock into portrait orientation, I scored at 1/2″ on one side and 1/2″ on the opposite side.  I cut at the 1/2″ mark down to the 6″ mark and adhered those extra little flaps down with sticky strip.  Then, I stamped the big, beautiful “Thank You” in white craft ink using the photopolymer set “Another Thank You”.

Thank You Gift Card 2I then added some Strawberry Slush stretch ruffle trim and a little bit of Winter Frost Speciality Designer Series Paper.

Thank You Gift Card 5To the inside, I used sticky strip to adhere a 3-3/4″ by 3-1/4″ piece of Coastal Cabana cardstock, which was scored at 3/8″ to secure to to the inside top flap of the gift card holder.  That way, when you open it up…

Thank You Gift Card 4…the gift card slides up!  Very cool!

Thank You Gift Card 6You can adhere the gift card with a glue dot so it stays in place.

I hope you enjoyed this project!

Thank You Gift Card 3

Supplies Used:

Stamp Set:

Another Thank You Photopolymer Stamp Set (133454)

Paper:

Coastal Cabana cardstock (131297)

Winter Frost Speciality DSP (132341)

Ink:

Whisper White Craft Stampin’ Ink Pad (101731)

Accessories/Tools:

Sticky Strip (104294

Stampin’ Trimmer (126889)

Strawberry Slush 3/8″ Ruffle Stretch Trim (130023)

Paper Snips (103579)

 

Happy Stamping,

Brooke

 

 

 

 

 

Advertisements